View source for Up Board Setup

== Basic requirements ==
=== Power Requirements ===

Please make sure you are using the correct PSU adapter with your board. Certified PSU are available from our shop: www.up-shop.org
<br /><br />
UP Board (5V only): 5V4A PSU https://up-shop.org/up-peripherals/65-dc-power-adapter-for-up-board-eu-plug.html
<br />
UP Core (5V only): 5V4A PSU https://up-shop.org/up-peripherals/65-dc-power-adapter-for-up-board-eu-plug.html
<br />
UP Squared (5V only): 5V6A PSU https://up-shop.org/up-peripherals/126-up-squared-power-supply-5v6a.html (power cord sold separately)
<br />
UP Core Plus (12V only): 12V5A PSU https://up-shop.org/up-peripherals/230-up-core-plus-power-supply-12v5a.html (power cord sold separately)
<br />
UP Xtreme (wide range 13+ to 60V): 19V3.42A PSU https://up-shop.org/up-peripherals/351-up-xtreme-power-supply.html (power cord sold separately)
<br />

=== Other Hardware Requirements ===

*USB stick to flash the Operating System Installer

To be able to set up the board, you'll need ''either'':

* Screen
* HDMI cable (or another video cable with a HDMI adapter)
* USB keyboard

''or'', to use the board through [[serial console]]:

* 10-pin connector adapter
* Serial cable

=== Alternative Power sources ===
*If your application doesn't require a lot of power, the UP board and UP Squared could also be powered through the 5V HAT pins
*(Early innovators only) pre-production revisions of the boards should '''only''' be powered through the DC jack.

== Setup guides ==
=== Linux ===
* [[Ubuntu]]
* Yocto
** [https://github.com/emutex/meta-up-board/blob/warrior/README.md Yocto 2.7 (Warrior)]
** [https://github.com/emutex/meta-up-board/blob/sumo/README.md Yocto 2.5 (Sumo)]
** [https://github.com/emutex/meta-up-board/blob/pyro/README.md Yocto 2.3 (Pyro)]
** [https://github.com/emutex/meta-up-board/blob/krogoth/README Yocto 2.1 (Krogoth)]
** [https://github.com/emutex/meta-up-board/blob/jethro/README Yocto 2.0.1 (Jethro)]

Deprecated:
* [[ubilinux]]™


=== Windows ===
This page will explain how to install Microsoft Windows 10 on any board from the UP Series.

It is assumed that the UP board is connected to a screen via HDMI cable and it has a mouse and keyboard also connected.

*Visit the [https://downloads.up-community.org/ download section] to get a copy of the Microsoft Windows 10&nbsp;Drivers package for UP Board (32 or 64bit depending on your installation).
*Then you can download the media creation tool from the official MS Windows website and follow the instructions provided by Microsoft to create a USB installer for Windows 10 to setup your system.

Videos and Tutorials from our Community:
*[https://www.youtube.com/watch?v=fIhT61Vlq-M Windows10 Install on an UP Board]

[[Category:Software]]

== [[FAQs]] ==
* [https://wiki.up-community.org/FAQs#Not_Booting_or_Powering_up Not-Booting or Powering-Up]
* [[Windows FAQs]]